For Tri - Proof Fixture , Dimmable Motion Sensor , Remote
Controllable and 1 ~ 10v Dimming
12V DC input motion sensor with 1~10v dimming output, special
housing designed for Tri-proof fixture application. Infrared remote
for end-user to change all the settings. Dual-processor technology
to differentiate the natural light and lamp light, daylight
monitoring function available.
Features--
Input voltage 12V DC (5V & 24V DC version available on request).
Input current:≥25mA.
1~10V dimming output signal.
Dual-processor technology, real Daylight monitoring function for
built-in application.
IR remote commissioning, easy setting and user friendly.
Detection range up to 12m in diameter.
Mounting height: 3~6m.
Settings(by remote control IR12)--
Permanent ON/OFF function
Press “ON/OFF” button, fixture goes to permanent on or permanent off mode, sensor
is disabled.
*press "Auto” ,”Reset" or “Ambient learn” to quit this mode.
Dim +/-
Press "Dim" button to automatically dim up or down the light
brightness during hold-time from 10% to 100%. Another press to lock
it down when desired brightness is achieved.
*after desired brightness is locked down, if user wants to dim
again reversely, just press the “Dim” button again and then lock down the new brightness again.
Sensor mode
Press “Auto” button, the sensor starts to work and all settings remain the same
as the latest status before the light was switched on/off.
Reset function
Press”Reset” button, all settings go back to factory default settings.
Ambient learn
Press "Ambient learn" button, the latest surrounding lux value
overwrites previous lux value learned, and set as the daylight
threshold. This feature enables the fixture to function well in any
real application circumstance.
Test mode
"Test mode"is for testing purpose only, for users to check the
functionality and choose the desired detection range. The sensor
goes to test mode automatically after pressing this button.
Users can quit this mode by pressing "ON/OFF", "Reset' or any
button of "Hold time". The sensor settings are changed accordingly.
In this mode, when used for on/off control, after motion detected,
sensor enters into a cycle of 3s on and 2s off. In this mode, when
used for tri-level dimming control, after motion detected, sensor
enters into a cycle of 3s on and 2s off(0.5s soft off + 1.5s off).
Detection pattern--
Daylight monitoring function--
Utilizing the Dual-processor technology, this sensor can tell the
difference of natural light and artificial light(lamp) from behind
the diffuser, switch on automatically(even without movements) when
the ambient light is below target value, and then switch off
automatically whenever the artificial light is not required
(ambient light is bright enough).
Note: Lux-Off sampling time—30s; Lux-On sampling time—10s.
Lux-On function takes effect only when standby dimming period set
at +∞.
